Original Concrete Mobile Home Steps

Ideas of Concrete Mobile Home Steps

Published On February 8, 2019 | By penulis | CONCRETE

Concrete mobile home steps – When repairing concrete driveways and steps, you may encounter several different types of damage. Both small and large cracks are common due to sedimentation of the soil under the structures. Accidents can also cause holes or turf in the surface. Weathering edges are common on the ladder due to the effects of being trampled on, bad weather and contact with salts and other corrosive substances. Any type of damage will require another suitable process to repair it.

Custom Concrete Mobile Home Steps

Custom Concrete Mobile Home Steps

Instructions

12 Photos Gallery of: Ideas of Concrete Mobile Home Steps

Image of: White Concrete Mobile Home Steps

Image of: Unusual Concrete Mobile Home Steps

Image of: Simple Concrete Mobile Home Steps

Image of: Outdoor Concrete Mobile Home Steps

Image of: Original Concrete Mobile Home Steps

Image of: Narrow Concrete Mobile Home Steps

Image of: Modern Concrete Mobile Home Steps

Image of: Low Concrete Mobile Home Steps

Image of: Large Concrete Mobile Home Steps

Image of: Image Concrete Mobile Home Steps

Image of: Design Concrete Mobile Home Steps

Image of: Custom Concrete Mobile Home Steps

Cracks

Place a tube of silicon zed latex seal in a pressure gun. Open the seal and place the tip as far into the crack as possible. Push the trigger on the gun to fill the crack tightly until full or slightly overfilled. Use a trowel to smooth the top of the seal so that it lies flat against the concrete mobile home steps edge of the knife to scrape off excess seal. Allow the filled cracks to dry for 24 hours before touching them.

Holes and Divots

Apply a 3/8-inch thick layer of concrete mobile home steps inside and around the edge of the hole or divot with pointed metal filler. Wait 1 to 2 hours until this patch is soft-set. Use putty to completely fill the hole or divot with concrete patch. Make up the patch even with the undamaged concrete around it. Wipe the filler clean or use second filler. Use the flat surface of the trowel to smooth the surface of the patch. Hold the trowel at a 45 degree angle and scrape up excess patch material with the angled edge. Allow the filled holes and / or divots to dry 24 to 48 hours before touching them.

Leave a Reply